The company’s new CVD series T-tinox class provides a new level of productivity for stainless steel turns. The copper-colored T-tinox coating is used to pile up the edges of the cutting edge, while ingersol’s t-turn + technology provides a smooth, stable cut edge. The new series includes three new levels.HG654 has high abrasion resistance and abrasion resistance and is an ideal choice for stainless steel high-speed continuous cutting.HG335 is suitable for general use of stainless steel. According to the company, it provides the best wear and tear resistance.HG654 provides crack resistance and toughness for cutting stainless steel at low cutting speed. The result is a smooth chip flow, optimal performance and extended tool life.
SC tools continues to strengthen its multidirectional steering (MDT) scheme, which recently announced the KK (trench) and KK (grooved) wafers for slot steel, nonferrous alloys and super alloys. The chip is characterized by a positive Angle of 10 degrees and an acute Angle of 10 microns. The geometry of KH is a sharp edge with no protection slot, mainly for non-ferrous alloys. The chip (pictured) has a chip circuit breaker that protects the slot from 0.1 mm to 0.2mm. The target is a super alloy but can also be applied to some steel applications., the company said the two chips have reduced the pressure of the cutting tool, in order to improve the productivity, and in the application is used as a “problem solvers”, in these applications, light cutting is more important than the chip breaking capacity. SC’s MDT is a flexible system that USES a single tool rack and a slotting cutter to rotate, profile, and slot on the axial and radial direction. The tool frame has a clamping motion, which reportedly provides a rigid and stable interface to make full use of the resources..