The company has introduced an ADFPI 8 round insert chip control that can be used in locks and upsets. In the case of standard and high performance, the insert of FLDC-3-8RDR75-CB, FLDC-3-8RDL75-CB and 16RD-CB can be used at the standard and high performance level, and the chip can be controlled when using ADFPI 8 wheel tool. You can make a special offer.
IS provides a set of hardened entanglement blades for the exponential model MH45 and the TAUB TNL and TNK mill/turn machines. Blade is suitable for separation and slotting between spindle and sub-spindle. The blade can be used in long-hanging applications due to its strengthening structure. Only the blades need to be reduced in width. According to the company, the rest are thick and can improve stiffness and stiffness.
SC provides two new insertion levels for milling titanium: S50H and S45H.According to the company, the S50H has a layer of PVD coating on a microcrystalline carbon substrate, so the sharp edges can resist fatigue and microcrystals.S45H is characterized by a type of CVD coating on the hard alloy substrate, which has a high toughness and can withstand vibration and cutting conditions. Used for plunge, side writing, slot milling, facemilling and shoulder milling CoroMill cutting tools for insertion.
SC tools has announced the company’s latest product, the GH50000, which is the latest product of a wear-resistant hard core coating. The new level is suitable for all kinds of steel processing operation, has stable cutting condition, and produces a lot of heat. Use GH50000 can significantly improve applications including those that require high metal removal rate of application, such as power generation part of the processing of large components, or found in the auto industry, high speed and high productivity applications. New level of benefits including higher speed cutting ability – even for a long time, less compensation to the machine, insert index for longer periods of time between machine more hard parts and tighter tolerances. The wear resistance is caused by the combination of the hard film coating and the thin substrate of plastic deformation.SC says its hardcore coating is 15 per cent harder than conventional coatings and 10 times harder than conventional coatings. In a test run under the same conditions, an insert with a dura mater is much colder than an identical coat embedded in the traditional alumina coating. This means fewer craters, less cut edges and longer tool life. In a complete set of clastic geometries, including negative insertion, positive insertion, and high source wiper insert, the level of GH50000 is provided.